Home
» C-BODY
» C-BODY TRANSMISSION
» All Products
Product ID 06030608
 
Transmission tube O ring
O-Ring for Transmission Tube.
Price$5.00
Product ID AX41T
WIRE RETAINING CLIP - MANUAL TRANS
WIRE RETAINING CLIP - MANUAL TRANS
Wire Retaining Clip for Manual Transmission Side Cover for the Reverse Light Switch Wire on 3- & 4-Speed Transmissions. Mounts Under Side Cover Retaining Bolts at Rear Top & Rear Upper Locations. Zinc Plated Correct Gauge Steel & Thermo-Plastic Coated for Proper Appearance. Two Wire Retaining Clips Required Per Transmission.
Price$7.00
Product ID 367-W
WOODGRAIN AUTOMATIC SHIFTER KNOB
WOODGRAIN AUTOMATIC SHIFTER KNOB
New reproduction woodgrain shifter knob for1967-71 A-body and 1966-70 B-body vehicles. Replace your old, damaged, or worn out shifter knob with our reproduction made to fit like original. This shifter knob comes with a woodgrain finish, a black button and is made to fit with original or aftermarket reproduction levers.
 
The woodgrain knob is original for 1969-71 A-Body and 1968-70 B-Body, but will also fit mid 60s console shifters as well.
 
2950713
Price$87.00
Product ID 2401910R
Z-BAR BALL STUD BEARING RETAINING WIRE
Z-BAR BALL STUD BEARING RETAINING WIRE

Price$8.00
Product ID 938(1)
Z-BAR BALL STUD BEARINGS
Z-BAR BALL STUD BEARINGS

Injection Molded in Delrin to Increase the Life & Reduce Friction, Yet Provides Correct Appearance of Nylon. Each Pair Fits Over the Z-Bar Ball Studs & Into the Z-Bar Tube. Two Pair are Required. Reference Chrysler # 2265938

Price$5.00
Product ID 2265942R
Z-BAR BALL STUD RUBBER SEAL
Z-BAR BALL STUD RUBBER SEAL

Injection Molded in Silicone Rubber for Higher Temperature Resistance & Long Life. Ball Side Lettering Shows Which Direction the Seal is to Be Installed. Keeps Dirt from the Ball Stud Bearings. Two are Required. Reference Chrysler # 2265942

Price$6.00
Product ID 2405086R
Z-BAR LINKAGE NYLON WEAR WASHER
Z-BAR LINKAGE NYLON WEAR WASHER

Price$3.00
Product ID 2405085R
Z-BAR LINKAGE SPRING CLIP
Z-BAR LINKAGE SPRING CLIP
(3) required per car
Spring steel clip that fits over the pivot stud of each end of the Z-Bar, and the clutch pedal linkage stud.  Secures the clutch actuator rods to the Z-Bar and clutch pedal linkage.  Reference Chrysler part number 2405085.
Price$4.95
« 123 Next »