Home
» B-BODY
» B-BODY TRANSMISSION
» Clutch
Product ID 420
GEARSHIFT CONTROL TORQUE SHAFT BUSHING
GEARSHIFT CONTROL TORQUE SHAFT BUSHING
Gearshift Control Torque Shaft Bushing. Used on 1967-74 A-, B-, C-, & E-Body Applications with Automatic Transmission. Two Bushings Required for Both Column & Floor Shifted Automatic Transmission Equipped Cars. Also, Two Bushings Required for 1970 4-Speed Reverse Lockout Linkage.
Price$5.00
Product ID AX41T
WIRE RETAINING CLIP - MANUAL TRANS
WIRE RETAINING CLIP - MANUAL TRANS
Wire Retaining Clip for Manual Transmission Side Cover for the Reverse Light Switch Wire on 3- & 4-Speed Transmissions. Mounts Under Side Cover Retaining Bolts at Rear Top & Rear Upper Locations. Zinc Plated Correct Gauge Steel & Thermo-Plastic Coated for Proper Appearance. Two Wire Retaining Clips Required Per Transmission.
Price$7.00
Product ID 2401910R
Z-BAR BALL STUD BEARING RETAINING WIRE
Z-BAR BALL STUD BEARING RETAINING WIRE

Price$8.00
Product ID 938(1)
Z-BAR BALL STUD BEARINGS
Z-BAR BALL STUD BEARINGS

Injection Molded in Delrin to Increase the Life & Reduce Friction, Yet Provides Correct Appearance of Nylon. Each Pair Fits Over the Z-Bar Ball Studs & Into the Z-Bar Tube. Two Pair are Required. Reference Chrysler # 2265938

Price$5.00
Product ID 2265942R
Z-BAR BALL STUD RUBBER SEAL
Z-BAR BALL STUD RUBBER SEAL

Injection Molded in Silicone Rubber for Higher Temperature Resistance & Long Life. Ball Side Lettering Shows Which Direction the Seal is to Be Installed. Keeps Dirt from the Ball Stud Bearings. Two are Required. Reference Chrysler # 2265942

Price$6.00
« Previous12 Next »